12.95
xii
E Siemens AG, 2002. All rights reserved
SINUMERIK 810D Manual Hardware Configuration (PHC) -- 11.02 Edition
4.6 PLC module 4-80................................................
4.7 PCMCIA card (memory card) 4-80..................................
4.8 CCU1: 6th axis (SW 3.2 and higher) 4-81............................
5 Axis Expansion 5-83.....................................................
5.1 Axis expansion plug-in unit 5-83....................................
5.2 Axis expansion with the SIMODRIVE 611D
closed-loop control module 5-86....................................
6 I/O Modules 6-89.........................................................
6.1 Single I/O module 6-89............................................
7 NCU Terminal Block 7-97.................................................
8 DMP Compact Modules 8-103..............................................
8.1 DMP compact module 16I (6FC5 111-0CA01-0AA0) 8-103..............
8.2 DMP compact module 16O (6FC5 111-0CA02-0AA1) 8-105............
8.3 DMP compact module 8O (6FC5 111-0CA03-0AA1) 8-107.............
8.4 DMP compact module 1I analog (6FC5 111-0CA04-0AA0) 8-109.........
8.5 DMP compact module 1I NC analog (6FC5 211-0AA10-0AA0) 8-112.....
8.6 DMP compact module 1O analog (6FC5 111-0CA05-0AA0) 8-115........
9 Maintenance and Service 9-117.............................................
9.1 W arning notices 9-117.............................................
9.2 Battery replacement
(6FC5 247-0AA18-0AA0, GWE-570 665 000 101) 9-118................
A Abbreviations A-121.......................................................
B References B-123..........................................................
C EC Declaration of Conformity C-135........................................
D Index Index-139..............................................................
11.02
To Next Page
Loading...
Need help?
General
