v
E Siemens AG, 2002. All rights reserved
SINUMERIK 810D Manual Hardware Configuration (PHC) -- 11.02 Edition
Preface
SINUMERIK documentation is split into three levels:
S General Documentation
S User Documentation
S Manufacturer/Service Documentation.
For more detailed information on SINUMERIK 810D publications and other pu-
blications covering all the SINUMERIK controls, please contact your local SIE-
MENS office.
You will also require the following
References: /PJU/ SIMODRIVE Planning Guide
As from 12.2001,
S SINUMERIK 810D powerline and
S SINUMERIK 810DE powerline
are available with improved performance. A list of the available powerline
modules can be found in the hardware description:
References: /PHC/ Configuration Manual SINUMERIK 810D
Armed with the information contained in this manual, it is possible to install the
SINUMERIK 810D numerical control and take measures to maintain and ser-
vice it.
If you have any questions, please call the following hotline:
A&D Technical Support Phone: +49(0)180-5050-222
Fax: +49(0)180-5050-223
Email: adsupport@siemens.com
For questions about the documentation (suggestions for improvement, correc-
tions) please send a fax to the following number or send an email:
Fax: +49 (0) 9131 98 -- 2176
E--mail: motioncontrol.docu@erl.siemens.de
Fax form: see feedback page at the end of this publication.
Internet address http://www.ad.siemens.de/sinumerik
S Project planning engineers, electricians and fitters
S Service and operating personnel.
Notes for the
reader
SINUMERIK 810D
powerline
Subject matter of
this manual
Hotline
Who is this
manual intended
for?
To Next Page
Loading...
