v
Copyright © Siemens AG 2006
SINUMERIK 810D Equipment Manual Configuration CCU (PHC) – 03/2006 Edition
!
Warning
indicates that death or serious injury may result if proper precautions are not
taken.
!
Caution
with a safety alert symbol, indicates that minor personal injury may result if
proper precautions are not taken.
Caution
without a safety alert symbol, indicates that property damage can result if
proper precautions are not taken.
Notice
indicates that an undesirable event or state may arise if the relevant notes are
not observed.
If several hazards of different degrees occur, the hazard with the highest degree
must always be given priority. If a warning note with a warning triangle warns of
personal injury, the same warning note can also contain a warning of material
damage.
Commissioning and operation of the device/equipment/system in question must
only be performed using this documentation. Only qualified personnel should
be allowed to commission and operate the device/system. Qualified persons
are defined as persons who are authorized to commission, to ground, and to tag
circuits, equipment, and systems in accordance with established safety practi-
ces and standards.
Please note the following:
!
Warning
The equipment may only be used for single purpose applications explicitly
described in the catalog and in the technical description and it may only be
used along with third-party devices and components recommended by
Siemens. To ensure trouble-free and safe operation of the product, it must be
transported, stored and installed as intended and maintained and operated with
care.
Qualified
personnel
Intended use
Preface
To Next Page
Loading...
Need help?
General
