Siemens SINUMERIK 840D sl TCU 30.3 - Page 28

OP 010, OP 010S, OP 010C, OP 012, OP 015, OP 015A, TP 015A and OP 019
Two mounting brackets (must be ordered separately) are required for mounting these
operator panel fronts (see Section "Accessories (Page87)").
1. Screw the mounting bracket ③ onto the TCU.
2. Use the two hinge catches ① to suspend the TCU mounting bracket unit (like a PCU) in the
operator panel front.
3. Insert cables K1, K2 and K3 (only for OP 019).
4. Close the cabled TCU mounting bracket unit and attach it using the four knurled screws ②.















① 2 x hinge catches
② 4 x knurled screws for attaching the mounting brackets to the operator panel front
③ 2 x mounting brackets
④ 10mm clearance
Figure4-1 Mounted TCU (example with OP 012) in front, side and rear view
Mounting
4.2Mounting the TCU on the operator panel front with mounting bracket
TCU 30.3
28 Equipment Manual, 03/2023, A5E40874197B AD