Siemens SIPART DR20 User Manual

Project Planning Manual SIPART DR20
•
Power supply
Rated voltage
Operating voltage range
Frequency range
Peak voltages:
Non-periodic (VDE 160) 1.3 ms
10 µS
Permissible voltage dips **)
(at maximum load)
Power consumption (at maximum load):
Apparent power (inductive)
Active power
Test voltages: (1 min)
Primary / secondary side
Primary side/protect. earth conductor
Secondary side/protect. earth conductor
AC 220/230/240 V
AC 195 to 276 V
48 to 63 Hz
≤ 780 V
≤ 1500 V
≤ 30 ms
≤ 21 VA inductive
≤ 13W
AC 1500 V
AC 1500 V
AC 500 V
AC 110/115/120 V
AC 97 to 138 V
48 to 63 Hz
≤ 390 V
≤ 1500 V
≤ 30 ms
≤ 21 VA inductive
≤ 13W
AC 1500 V
AC 1500 V
AC 500 V
UC 24 V
AC 20 to 28 V
48 to 63 Hz
≤ 78 V
≤ 500 V
≤ 30 ms
≤ 21 VA inductive
≤ 13W
AC 500 V
DC 700 V
DC 700 V
DC 20 to 35 V
≤ 78 V
≤ 500 V
≤ 30 ms
≤ 13W
AC 500 V
DC 700 V
DC 700 V
**) The transmitter supply can fall by up to 5 V, the max. load voltage of the manipulated variable current Iy from
18 to 13 V.
• Transmitter supply L+
Rated voltage
Residual ripple (100/120 Hz) Upp
Max. permissible load current
Short-circuit current
20 to 26 V
≤ 1 V
60 mA, short-circuit-proof
< 200 mA, puIsed
• Analog inputs AE1 and AE2 (standard controller)
Input signal range *)
Input resistance
Filter time constant
Static destruction limit
Dynamic destruction limit
0 to 20 mA or
4 to 20 mA
249 Ω ± 0.1%
approx. 25 ms
- 8 / + 30 mA
± 500 V
(1.2 / 50 µS, Ri = 13 Ω)
• Digital input BE
Signal state "0" *)
Signal state" 1" *)
Input resistance
Static destruction limit
Dynamic destruction limit
≤ 4.5 V or open
≥ 13 V
≥ 27 kΩ
± + 35 V
± + 500 V
(1.2 / 50 µS, Ri = 13 Ω)
*) Referred to M
64

Siemens SIPART DR20 Specifications

General

Brand	Siemens
Model	SIPART DR20
Category	Controller
Language	English