Operation
95
SIPAR T PS2 Manual
A5E00074631--06
See chapter 4.5, page 122 for further information.
.
NOTE
The respective operating mode (MAN or AUT) of the positioner is retai-
ned when you switch to the diagnostic display, i.e. in automatic opera-
tion the specified setpoint is still used for controlling and in manual
operation the position last reached is retained.
4.4 Parameters
All the parameters of the positioner are listed in this chapter . Figure 4-6
shows an overview of the parameters.
The parameter name is shown once in plain text and once as it ap-
pears in the display. The function of the parameter is described briefly
in the “Function” column. In addition, the possible parameter values,
the physical unit and the factory setting of the parameters are shown.
To Next Page
Loading...
Need help?
General
