Siemens SIRIUS 3RW30 - Commissioning; 13.1 Commissioning the 3 RW30

SIRIUS 3RW30 / 3RW40
Manual, 10/2018, NEB535199502000/RS-AB/005
103
Commissioning
13
13.1
Commissioning the 3RW30
Commissioning, description of the start and output parameters
13.1.1
Commissioning procedure
1. Check the voltages and wiring.
2. Set the start parameters (for recommended parameters, refer to the quick commissioning
table).
3. Start up the motor and if necessary optimize the parameters (refer to the quick
commissioning table).
4. Document the parameter settings if required (refer to chapter Table of parameters used
(Page 199)).