Siemens SIRIUS 3RW30 - Acknowledging Faults; SIRIUS 3 RW405 and 3 RW407 Soft Starters; Setting the RESET MODE; Manual RESET

Functions
5.4 Functions of the RESET buttons
SIRIUS 3RW30 / 3RW40
Manual, 10/2018, NEB535199502000/RS-AB/005
49
5.4.1.5
Acknowledging faults
For information on whether faults can be acknowledged, and on the corresponding LED and
output contact states, refer to chapter Messages and diagnosis (Page 57).
5.4.2
SIRIUS 3RW405 and 3RW407 soft starters
5.4.2.1
Setting the RESET MODE
Auto RESET
Yellow
Manual RESET / (remote RESET)
Off (factory setting)
RESET MODE button
By pressing the RESET MODE button, you define the reset procedure in case of a fault. This
is indicated by the AUTO LED.
5.4.2.2
Manual RESET
Manual RESET with the RESET/TEST button (LED AUTO is off)
You can reset a fault by pressing the RESET/TEST button.