Siemens SIRIUS 3RW30 - 11.2 Operator controls, displays, and connections on the 3 RW40

Operation
11.2 Operator controls, displays, and connections on the 3RW40
SIRIUS 3RW30 / 3RW40
82 Manual, 10/2018, NEB535199502000/RS-AB/005
11.2
Operator controls, displays, and connections on the 3RW40
1
Operating voltage (three-phase mains voltage)
2
Control supply voltage
3
IN start input
4
ON / RUN output
5
BYPASSED output
6
DEVICE / STATE / BYPASSED / FAILURE status LEDs
7
OVERLOAD, RESET MODE status LEDs
8
TEST / RESET button
9
Current limiting
10
Ramp-up time
11
Starting voltage
12
Ramp-down time
13
Trip class
14
Motor current
15 Thermistor input (can be optionally ordered with 24 V AC/DC control voltage for 3RW402. to
3RW404. devices)
16
Fault output
17
Motor terminals
18
RESET MODE button (behind the label on the 3RW402., refer to the diagram below)