Commissioning
13.1 Commissioning the 3RW30
SIRIUS 3RW30 / 3RW40
108 Manual, 10/2018, NEB535199502000/RS-AB/005
ON output
ON output contact
State diagram of the ON output contact
The output contact at terminal 13/14 (ON) closes if a signal is present at terminal 1 (IN); it
remains closed until the start command is removed.
The output can be used, for instance, to control a line contactor connected upstream or to
implement latching if you selected pushbutton control. For recommended circuits, refer to
chapter Typical circuit diagrams (Page 161).
For the state diagram of the contacts in the various operating states, refer to chapter
3RW30: LEDs (Page 57).
To Next Page
Loading...
