Siemens SIRIUS 3UG4 - Page 45

Menu-based operation
...
...


(5525
12(5525
0HPRU\ \HV
!V
12(5525
0HPRU\ QR
Threshold1
Threshold2
Threshold3
Parameter3
Parameter2
Parameter1
(UURU
(UURU
(UURU
0HDV9DOXH
0HDV9DOXH
6(7
581
(5525
2.
!VV



9$/8(

① RUN - OK Status display in the correct range, see below
• Measured value1 / Meas‐
ured value2 / ...
② RUN - VALUE Settings of the monitored thresholds, see below
③ RUN - ERROR Status display in the event of a fault
If a threshold is overshot or undershot, the outputs of the monitor‐
ing relays switch over after the set delay time. The display indicates
the type of error.
• Error1 / Error2 / ... Error detected
④ SET Settings for basic device parameters, see below
System overview
3.6 Menu-based operation
SIRIUS 3UG4 / 3RR2 monitoring relay
Equipment Manual, 07/2021, NEB927043002000/RS-AD/005 45