Siemens SIRIUS 3UG4 - Page 47

Navigation in the menu
There are basically two ways of navigating on both menu levels:
• Brief pressing the SET key
(≤ 0.5 s)
You can jump from one parameter to the next within one menu level by brie󹪞y pressing the
SET key . The order is not variable.
Entry Display at the RUN menu level Display at the SET menu level
1. Current measuring value (MeasValue1 /
MeasValue2 / ...) or error symbol (Error1 /
Error2 / Error3 / ...), switching contact sym‐
bols and monitoring methods for diagnostics
Parameter1
2. Threshold1 Parameter2
3. Threshold2 Parameter3
4. Threshold3 ...
5. ...
Note
The setting options a device actually o󹪜ers depends on the type and can be looked up in the
relevant chapters on operation in this manual.
You can 󹪝nd full details of menu-based operation for the individual devices in Appendix D
"Menu-based operation" (Page 307).
• Pressing and holding the SET key (> 2.5 s)
By pressing and holding the SET key , the menu changes from RUN to SET and vice versa.
– RUN → SET
Menu level change can be started from any display. While the SET key is pressed,
appears on the display.
After a successful change, you always arrive at the 󹪝rst menu item (parameter1) of the
"SET" menu level.
In the event of an error, changing to the "SET" menu level is only possible from "RUN-
VALUE" ②. If an error is indicated, the SET key must be pressed 󹪝rst brie󹪞y (< 0.5 s).
– SET → RUN
You can switch menus from any of the menu commands. While the SET key is
pressed, appears on the display.
After a successful change, you arrive at current measuring value (measuringvalue1) or
the current error of the RUN menu level.
Note
Aborting the menu switchover
The switchover process will be interrupted if the SET key is released while or is
displayed. The menu will revert to the menu command you were working with when the switch
was initiated.
System overview
3.6 Menu-based operation
SIRIUS 3UG4 / 3RR2 monitoring relay
Equipment Manual, 07/2021, NEB927043002000/RS-AD/005 47