Pay attention to the following residual risks:
1.
Unintentional movements of driven machine parts
Unintentional movements of driven machine parts can occur during commissioning,
operation, maintenance, and repair, e.g. from the following causes:
– Hardware defects and/or software errors in the sensors, controllers, actuators, and
connection technology
– Response times of the controller and drive
– Operating and/or environmental conditions outside of the specification
– Condensation/conductive contamination
– Parameterization, programming, cabling, and installation errors
– Use of radio devices/cellular phones in the immediate vicinity of the controller
– External influences/damage
2. High temperatures and emissions
A fault can occur as a result of the following, for example:
– Component malfunctions
– Software errors
– Operating and/or environmental conditions outside of the specification
– External influences/damage
A fault can, for example, have the following consequences both inside and outside the drive:
– Extraordinarily high temperatures, including open fires as a result of the fault
– Emissions of light, noise, particles or gases
Drives with open type / IP20 degree of protection must be installed in an electrical room or
a comparable environment.
3. Hazardous shock voltages
Hazardous shock voltages can result from the following causes, for example:
– Component malfunctions
– Induction of voltages in moving motors
– Operating and/or environmental conditions outside of the specification
– Condensation/conductive contamination
– External influences/damage
4. The release of substances and emissions that are harmful to the environment
Improper operation or the improper disposal of components can harm the environment.
Safety notes
1.7 Residual risks
Applications for Cabinet Modules, liquid cooled
22 Operating Instructions, 04/2015, A5E35974555A
To Next Page
Loading...
Need help?
General