Siemens SITRANS F M MAG 1100 - 6 Service and Maintenance; Maintenance; Recalibration; Unit Repair

Service and maintenance
6
6.1 Maintenance
The device is maintenance-free. However, a periodic inspection according to pertinent
directives and regulations must be carried out.
An inspection can include check of:
● Ambient conditions
● Seal integrity of the process connections, cable entries, and cover screws
● Reliability of power supply, lightning protection, and grounds
NOTICE
Repair and service must be carried out by Siemens authorized personnel only.
Note
Siemens defines flow sensors as non-repairable products.
6.2 Recalibration
Siemens A/S Flow Instruments offers to recalibrate the sensor. The following calibration is
offered:
● Standard matched pair calibration
● Customer-specified calibration up to 10 points
● Customer-witnessed calibration
Note
For recalibration the memory unit must always be returned with the sensor.
6.3 Unit repair
NOTICE
Repair and service must be carried out by Siemens authorized personnel only.
Note
Siemens defines flow sensors as non-repairable products.
SITRANS F M MAG 1100 sensor
Operating Instructions, 01/2018, A5E03433301-AC 41