Troubleshooting
9.4 Application information guide
SITRANS F M TRANSMAG 2
70 Operating Instructions, 11/2009, A5E00102775-07
Note
Sketch
It is recommended to prepare a diagram/sketch of the installation/application explaining inlet
and outlet conditions; distance from pump; etc.
Table 9- 3 Application data
Liquid
• Media conductivity
• Media name
• Chemical formula
• Gas (%-vol)
• Solids - kind and concentration (%-weight)
• Media density
• Media viscosity
Pipe size
Process tempearture
Ambient temperature
Process pressure
Liner type
Table 9- 4 Sensor/converter data
Serial-No./Komm.-nr. transmitter Type plate
Order No. converter Menu 5.2.1 7ME
Serial-No./Komm.-nr. sensor Type plate
Order No. sensor Menu 5.2.6.2 7ME
Current flow Menu 1.3
Flow velocity [m/s] Menu 1.5
Current output [mA] Menu 1.7
Device status / error messages Menu 2.1
Engineering unit Menu 3.1.1
Flow upper range value (URV) Menu 3.1.2
Flow direction (+/-) Menu 3.1.5.1
Measuring direction (forward/reverse) Menu 3.1.5.2
Hysteresis Menu 3.1.5.3
Low flow cut-off (1%) Menu 3.1.6
Time constant (3.00 sec.) Menu 3.1.7.1
Slurry mode (off) Menu 3.1.8
Pulse rate / unit Menu 4.2.3
Pulse width Menu 4.2.4
To Next Page
Loading...
