Device configuration – all modules selected
As shown to the right all modules are selected in the GSD
file.
Default unit selection of process values
The device provides the possibility to select units for proc‐
ess values.Units are only valid for PROFIBUS, local HMI
display units will not be changed. Select object properties
of the transmitter icon and then Parameter assignment.
Click on device –specific parameters or configured by a pa‐
rameterization tool like SIMATIC PDM.
Startup parameter
Applied:
Selected units will overwrite the units that are selected in
the HMI display for PROFIBUS.
Ignored:
Selected units in the HMI display for PROFIBUS or config‐
ured by a parameterization tool like SIMATIC PDM will not
be overwritten.
Communication
2.9 Cyclic data exchange
FCT030 Profibus (From firmware 4.0)
Function Manual, 06/2018, A5E39931906-AB 25
To Next Page
Loading...
