Slot configuration
The GSD file provides the possibilitiy to configure up to 15
modules.
Each module is linked to a specific process value or control
value in the device. It is recommended only to configure
modules that are processed by the master. If a process
value or a control value is not needed insert
Not in cyclic
data transfer
For Totalizer modules as Mass total, Volume total, Stand‐
ard volume total, Fraction A total or Fraction B total can
freely be selected in the slot that are assigned to Totalizer
1, 2, 3.
Default slot configuration
The GSD file provides the default slot configuration, as
shown to the right.
Slot 7,8,9 and 10 are specific for Fraction information.
Fraction information is only relevant if the device is ordered
with fraction option.
Communication
2.9 Cyclic data exchange
FCT030 Profibus (From firmware 4.0)
24 Function Manual, 06/2018, A5E39931906-AB
To Next Page
Loading...
