Siemens SITRANS P DS III - Page 38

Maintenance and servicing
5.6 User data following replacement
SITRANS P DS III
38 Service Manual, 06/2014, A5E34219855-01
Parameter name in SIMATIC PDM
Status of user data following replacement of application electronics or
measuring cell
Identification / operating unit / message
②
Identification / device / device serial number
②
Identification / device / software revision
②
Identification / device / hardware revision
②
Identification / device / PROFIBUS Ident
Number
②
Identification / device / installation date
②
Identification / device / Order No.
②
Input / transducer block 1 / transducer type
②
Input / transducer block 1 / measuring limits /
pressure unit, raw value
②
Input / transducer block 1 / measuring range /
unit (secondary variable 1)
②
Input / transducer block 1 / measuring range /
start-of-scale value
②
Input / transducer block 1 / measuring range /
full-scale value
②
Input / transducer block 1 / working range /
unit
②
Input / transducer block 1 / working range /
start-of-scale value
②
Input / transducer block 1 / working range /
full-scale value
②
Input / transducer block 1 / characteristic /
low-flow cut-off
②
Input / transducer block 1 / characteristic /
start of root function
②
Input / transducer block 1 / interpolation points
(all settings)
②
Input / transducer block 1 / sensor
temperature / temperature unit
②
Output / Function Block 1 - analog input (all
settings)
②
Output / Function Block 2 - totalizer (all
settings)
②
Display and user interface / local operation
②
Display and user interface / source for display
②
Display and user interface / decimal places in
display
②
Diagnostics settings / enabling of diagnostics
②
Diagnostics settings / calibration interval for
application electronics (all settings)
②