Siemens SITRANS P DS III - 1 Introduction; Purpose of this Documentation; Product Information; History

SITRANS P DS III
Service Manual, 06/2014, A5E34219855-01
7
Introduction
1
1.1
Purpose of this documentation
These instructions contain all information that you will require to replace the application
electronics, measuring cell, and connection board of the device.
For information about the safe usage of the device, refer to the detailed version of these
instructions and corresponding safety instructions on the electronic data medium.
Read these instructions carefully before you start any service and maintenance work. In
order to use the device correctly, first make yourself acquainted with its principle of
operation.
Readership of these instructions are service and maintenance technicians.
1.2
Product information
The programming manual is an integral part of the CD, which is either supplied or can be
ordered. The programming manual is also available on the Siemens homepage.
On the CD, you will also find the catalog extract with the ordering data, the Software Device
Install for SIMATIC PDM for additional installation, and the required software.
See also
Product information on SITRANS P in the Internet (http://www.siemens.com/sitransp)
Catalog process instrumentation (http://www.siemens.com/processinstrumentation/catalogs)
1.3
History
This history establishes the correlation between the current documentation and the valid
firmware of the device.
The documentation of this edition applies to the following firmware:
Edition
Firmware identifier nameplate
System integration
Installation path for PDM
06/2014 HART:
FW: 11.03.03, FW: 11.03.04,
FW: 11.03.05, FW: 11.03.06
PA: FW: 301.01.10
FF: FW: 11.01.01
SIMATIC PDM 8.x and
previous versions
SITRANS P DSIII.2