Siemens SITRANS P DS III - Checking the Compatibility of the Application Electronics

Introduction
1.6 Checking the compatibility of the application electronics
SITRANS P DS III
Service Manual, 06/2014, A5E34219855-01
9
Operate the device in accordance with the "Technical specifications" chapter in the operating
instructions.
For additional information, refer to the operating instructions for the device.
1.6
Checking the compatibility of the application electronics
1. The table shown below indicates whether the new application electronics matches the
device.
2. Check the product version on the application electronics sticker.
3. Check the compatibility mark on the nameplate of the device.
Table 1- 1 The following table is valid for: SITRANS P DS III with HART (7MF4.33..)
Product version (ES)
Compatibility mark
Remark
007 to 025 K = 01 Replacement not possible
030 to 035 K = 01 Replacement possible
Table 1- 2 The following table is valid for:
SITRANS P DS III with PA (7MF4.34..) and SITRANS P DS III with FF (7MF4.35..)
Product version (ES)
Compatibility mark
Remark
001 to 015 K = 01 Replacement possible