Siemens SITRANS P DS III - Installation Location and Proper Mounting

Maintenance and servicing
5.7 Replacing parts
SITRANS P DS III
Service Manual, 06/2014, A5E34219855-01
43
To install the connection board, proceed as follows
1. Insert the new connection board so that its contact pins on rear side mate the contacts in
the housing.
2. Work in the reverse order as described in "Procedure for replacing the connection board".
3. Close the device as described in Chapter Closing the device (Page 26).
5.7.4
Replacing the pushbutton module
1. Isolate the device from power.
2. In order to open the pushbutton flap, loosen the two recessed-head screws on the
outside.