Siemens SITRANS P DS III - Replacing the Connection Board

Maintenance and servicing
5.7 Replacing parts
SITRANS P DS III
Service Manual, 06/2014, A5E34219855-01
41
5.7.3
Replacing the connection board
Procedure for replacing the connection board
1. Isolate the device from power.
2. Use a 3 mm Allen key to loosen the cover.
3. Open the cover (rear) of the electronic connection compartment.
4. Disconnect the cables from the connection board.
5. On the left and right side, remove the recessed-head screws that hold the connection
board to the enclosure.