Siemens SITRANS P DS III - Page 46

Maintenance and servicing
5.7 Replacing parts
SITRANS P DS III
46 Service Manual, 06/2014, A5E34219855-01
3. Pull the display out of the housing.
4. Remove the connector of the ribbon cable from the application electronics.
Procedure for installing the display
1. You can also turn the mounting position of the display by 90 ° or 180 °.
2. Work in the reverse order as described in "Procedure for replacing the display".
3. Close the device as described in Chapter Closing the device (Page 26).