Siemens SITRANS SL - Page 173

Alarm, error, and system messages
10.2 Alarm list
SITRANS SL
Operating Instructions, 12/2010, A5E01132948-04
175
Table 10- 1 Alarm list sorted by Error Codes
Error
Code
Alarm (description) Alarm Application Status LUI Group
E1 No transmission Process value fault G7
E2 Low transmission Maintenance demanded G7
E3 Receiver power Maintenance demanded G2
E4 Receiver junction power Maintenance demanded G2
E5 Transmitter power Maintenance demanded G5
E6 Startup procedure active Maintenance fault G4
E8 Line locking failure Maintenance fault G4
E9 Save settings active Service G6
E10 Process temp. range Process value warning G10
E11 Process pressure range Process value warning G11
E12 Ext. temperature bad Process value fault G1
E13 Ext. temperature low limited Process value warning G1
E14 Ext. temperature high limited Process value warning G1
E15 Ext. temperature constant Process value tolerance G1
E16 Ext. pressure bad Process value fault G1
E17 Ext. pressure low limited Process value warning G1
E18 Ext. pressure high limited Process value warning G1
E19 Ext. pressure constant Process value tolerance G1
E20 Ext. temperature source disconnected Process value fault G1
E21 Ext. pressure source disconnected Process value fault G1
E23 Ext. temperature uncertain Process value tolerance G1
E24 Ext. pressure uncertain Process value tolerance G1
E25 PROFIBUS configuration error Data exchange / No data exchange G13
E26 PROFIBUS connection error Data exchange / No data exchange G13
E27 PROFIBUS master switch off Data exchange / No data exchange G13
E28 PROFIBUS internal error Data exchange / No data exchange G13
E29 Compensation temp file range Process value fault G10
E30 Compensation prs file range Process value fault G10
E31 CurveFit temp. file range Process value fault G10
E32 CurveFit pressure file range Process value fault G10
E33 CurveFit gas file range Process value fault G10
E35 O
2
outside range Process value warning G10
E41 CO outside range Process value warning G10
E45 FPGA timeout receiver Maintenance fault G12
E46 FPGA timeout receiver junction Maintenance fault G12
E47 FPGA timeout transmitter Maintenance fault G12
E48 Laser unpowered Maintenance fault G5
E49 Transmitter board temperature Maintenance demanded G5
E50 Receiver board temperature Maintenance demanded G2