Siemens Stratos Outstation - Page 62

Mobility, Intelligent Traffic Systems
Sopers Lane, Poole, Dorset, BH17 7ER
Security classification Unrestricted Page 62 of 92
Version 3 Status Issued
Last Editor Alan Doyle Date 05-Oct-2017
Document Name Stratos Outstation General and ICM Handbook Document No. 667/HB/52250/000
Copyright © Siemens plc 2014. All Rights Reserved. Mobility and Logistics is a division of Siemens Plc
• HTTPS (TCP 443)
o www.stratostraffic.com (TLS trusted time)
o www.stratosemerge.com (CRLs)
o ovpn1.stratostraffic.com (OpenVPN)
• HTTP or HTTPS (TCP 80 or 443)
o OCSP authenticator for stratosemerge HTTPS certificate (OCSP)
Other applications and features of the equipment may require access to additional
services either on the internet or on a local network. The documentation for these
applications and features record these requirements.
Licence Card
A Licence Smartcard version 2 is required to support connections to Stratos. The version
of the Licence Smartcard fitted can be checked on the System – Settings – Comms –
Stratos configuration web page.
The UTMC OTU licence controls whether or not connection to Stratos is supported – see
section 3.17.
Ethernet Configuration
Ethernet can be fully configured manually if required but configuration can be minimised
by using DHCP.
To connect the equipment to Stratos perform the following:
1. Set the date and time (System - Settings - System Date & Time - Set System Date
& Time web page).
2. On the System - Settings - Comms – Stratos web page:
• Set the Tenant Pass Phrase.
• Set the Site Location.
• Set the Site Name.
3. Set the profile to Stratos (System – Settings web page).
4. Check that Ethernet is suitably configured (System - Settings - Comms - DSL/Fibre
web page). Using the Stratos profile sets this to DHCP. If this not suitable then
configure as required.