Mobility, Intelligent Traffic Systems
Sopers Lane, Poole, Dorset, BH17 7ER
Security classification Unrestricted Page 53 of 92
Version 3 Status Issued
Last Editor Alan Doyle Date 05-Oct-2017
Document Name Stratos Outstation General and ICM Handbook Document No. 667/HB/52250/000
Copyright © Siemens plc 2014. All Rights Reserved. Mobility and Logistics is a division of Siemens Plc
Detector Function Card/ Port Bit ID
4
Loop 1 Detect 5
Loop 2 Detect
6
Loop 3 Detect 7
Loop 4 Detect
8
- Not Used
1-8
1 Detector Reset
GspiX.out.3
1
2 Detector Reset
2
3 Detector Reset
3
4 Detector Reset
4
- Not Used
5-8
Table 21 – IDB IO Mapping
Note: X denotes gspi card number (the same as card address).
4.10 Single Detector Backplane
Loop detectors can be connected using the single detector backplane 667/1/17205/000.
The channel outputs on this backplane need to be wired to the TR2523 inputs on the IO or
PSU boards. The backplane pinout is shown in Figure 18.
Figure 18 – Single Detector Backplane Wiring
To Next Page
Loading...
