Troubleshooting de
disturbance Cause and troubleshooting
flashes. If the voltage drops below this limit, the program can
be extended.
No fix possible.
Detergent dosage is too high.
▶ Immediate action: Mix one tablespoon
Softener with 0.5 liters of water and pour the
mixture into the compartment for manual dosing
(not for outdoor, sportswear and down textiles).
▶ When intelligent dosing is activated,
like the basic dosage →
Page 49.
▶ If you dose manually, decrease the
the amount of detergent for the next wash cycle
with the same load.
shines. Temperature is too high.
▶ Wait until the temperature has dropped.
▶ → "
Abort program ", page 46
The water level is too high.
▶ Start the program Pumping out.
Laundry is jammed in the door.
1. Open the door again.
2. Remove jammed laundry.
3. Close the door.
4th To start the program, press .
flashes. Door is not closed.
1. Close the door.
2. To start the program, press .
All other fault co-malfunction
▶ Call customer service.
→
"Customer service", page 76
of.
Device works
not.
The mains plug of the mains connection cable is not
plugged in.
▶ Connect the device to the mains.
The fuse is defective.
▶ Check the fuse in the fuse box.
Power supply has failed.
▶ Check whether the room lighting or other
Devices in the room work.
Program starts
not.
was not pressed.
▶ Press .
65
To Next Page
Loading...
