Troubleshooting de
disturbance Cause and troubleshooting
The detergent solution does not come out. Drain pipe or water drainage hose is blocked.
pumped out.
▶ Clean the drain pipe and water drain
running hose.
The drain pipe or water drainage hose is kinked or
pinched.
▶ Make sure the drain pipe and the
The water drainage hose is not kinked or trapped.
The drain pump is blocked.
▶ → "
Cleaning the drain pump ", page 57
is activated.
▶ Continue the program by pressing Sluice
change or Pumping out select and press.
The water drainage hose is connected too high.
▶ Mount the water drainage hose in maxi-
times 1 meter in height.
Detergent dosage is too high.
▶ Immediate action: Mix one tablespoon
Softener with 0.5 liters of water and pour the
mixture into the compartment for manual dosing
(not for outdoor, sportswear and down textiles).
▶ When intelligent dosing is activated,
like the basic dosage →
Page 49.
▶ If you dose manually, decrease the
the amount of detergent for the next wash cycle
with the same load.
Inadmissible extension mounted on the water
drainage hose.
▶ Remove impermissible extensions from the water
drain hose. Connect device
Water does not run in. Detergent won't
▶ Press
was not pressed.
.
washed in.
The filters in the water inlet are blocked.
▶ Clean the filters in the water inlet →
Page 60.
The tap is closed.
▶ Open the faucet.
The water inlet hose is kinked or pinched.
▶ Make sure that the water inlet hose
is not kinked or pinched.
67
To Next Page
Loading...
