de Troubleshooting
disturbance Cause and troubleshooting
Repeated arrival
sling.
The unbalance control system compensates for the unbalance
by distributing the laundry several times.
▶ No mistake - no action required.
Note: When loading, place large and small items of
laundry together in the drum. Laundry items of
different sizes are better distributed during spinning.
Program duration change The program sequence is electronically optimized. This can
lead to a change in the duration of the program.
▶ No mistake - no action required.
changes during the
Washing process.
The unbalance control system compensates for the unbalance
by distributing the laundry several times.
▶ No mistake - no action required.
Note: When loading, place large and small items of
laundry together in the drum. Laundry items of
different sizes are better distributed during spinning.
The foam control system switches on a rinse cycle if the
foam builds up too much.
▶ No mistake - no action required.
Water is not visible
in the drum
bar.
Water is below the visible range.
▶ No mistake - no action required.
▶ Do not fill an additional one during operation
Water into the device.
Drum jerks behind
Program start.
The cause is an internal motor test.
▶ No mistake - no action required.
Vibrations and movement
the appliance during
spinning.
Device is not aligned correctly.
▶ Align the device
The feet of the device are not fixed.
▶ Fix the device feet. Align the device
Transport locks are not removed.
▶ Remove the transport locks
Drum turns,
Water does not run in.
Load detection is active.
▶ No mistake, no action necessary.
Note: The load detection can take up to 2 minutes.
68
To Next Page
Loading...
