EasyManua.ls Logo

Siemens WM14UP40 - Page 69

Siemens WM14UP40
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting de
disturbance Cause and troubleshooting
Strong foaming
manure.
Detergent dosage is too high.
Immediate action: Mix one tablespoon
Softener with 0.5 liters of water and pour the
mixture into the compartment for manual dosing
(not for outdoor, sportswear and down textiles).
When intelligent dosing is activated,
like the basic dosage
Page 49.
If you dose manually, decrease the
the amount of detergent for the next wash cycle
with the same load.
i-Dos i-Dos Intelligent dosing is not planned for this program.
No mistake - no action required.
cannot be actuated
will.
Program progress does not allow intelligent dosing.
No fix possible.
High spin speed
number is not
reached.
The low spin speed is set.
Set a higher one for the next wash cycle
Spin speed.
is activated.
Select programs suitable for the type of textile
the end.
"Programs", page 29
The unbalance control system compensates for unbalance
by reducing the spin speed.
Redistribute the laundry in the drum.
Note: Place large and small items of laundry together
in the drum. Laundry items of different sizes are
better distributed during spinning.
Start the program Sling.
Spin program
does not start.
The drain pipe or water drainage hose is blocked.
Clean the drain pipe and water drain
running hose.
The drain pipe or water drainage hose is kinked or
pinched.
Make sure the drain pipe and the
The water drainage hose is not kinked or trapped.
69

Table of Contents

Related product manuals