de Troubleshooting
disturbance Cause and troubleshooting
Spin program The unbalance control system has stopped spinning
due to uneven distribution of the laundry.
▶ Redistribute the laundry in the drum.
does not start.
Note: Place large and small items of laundry together
in the drum. Laundry items of different sizes are
better distributed during spinning.
▶ Start the program Sling.
Rustling, zi-
screeching sound.
Water is rinsed into the detergent drawer under
pressure.
▶ Not a fault - normal operating noise.
Longer, whirring one
Noise before the start
of washing or
Fabric softener.
Intelligent dosing system doses detergent or care
products.
▶ Not a fault - normal operating noise.
Short, whirring
noise after switching on
the device.
Intelligent dosing system carries out a function test.
▶ Not a fault - normal operating noise.
Loud noises during
rend of skidding.
Device is not aligned correctly.
▶ Align the device
The feet of the device are not fixed.
▶ Fix the device feet. Align the device
Transport locks are not removed.
▶ Remove the transport locks
Rattling noises,
Rattling in the lye
pump.
Foreign matter has got into the drain pump.
▶ → "
Cleaning the drain pump ", page 57
Slurping, rhythmic
nice sucking noise.
The detergent solution pump is active, the detergent solution is being
pumped out.
▶ Not a fault - normal operating noise.
Wrinkling. Spin speed is too high.
▶ For the next wash cycle, set a low
adjust the spin speed.
Load is too high.
▶ For the next wash cycle, reduce the load
amount of manure.
The wrong program has been selected for the type of fabric.
▶ Select programs suitable for the type of textile
the end.
→
"Programs", page 29
70
To Next Page
Loading...
