EasyManua.ls Logo

Siemens WM14UP40 - Page 71

Siemens WM14UP40
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Troubleshooting de
disturbance Cause and troubleshooting
Spin result is
not satisfied-
lend. The laundry is
too wet / too damp.
The low spin speed is set.
Set a higher one for the next wash cycle
Spin speed.
Start the program Sling.
is activated.
Select programs suitable for the type of textile
the end.
"Programs", page 29
The drain pipe or water drainage hose is blocked.
Clean the drain pipe and water drain
running hose.
The drain pipe or water drainage hose is kinked or
pinched.
Make sure the drain pipe and the
The water drainage hose is not kinked or trapped.
The unbalance control system has stopped spinning
due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
Note: Place large and small items of laundry together
in the drum. Laundry items of different sizes are
better distributed during spinning.
Start the program Sling.
The unbalance control system compensates for unbalance
by reducing the spin speed.
Redistribute the laundry in the drum.
Note: Place large and small items of laundry together
in the drum. Laundry items of different sizes are
better distributed during spinning.
Start the program Sling.
Detergent residue
de on the damp
laundry.
Detergents can contain water-insoluble substances
that are deposited on the laundry.
Start the program Wash.
Unsuitable detergent filled into the dispenser of the
intelligent dispensing system.
1. Check whether the detergent used is suitable.
"Detergents and care products", page 42
71

Table of Contents

Related product manuals