Silvercrest SKM 600 C2 - Basic Operation; Power Supply; Safety Functions

29
GB
8. Figure B: press the mixing tool4/6/7
upwards slightly and rotate it in the di-
rection of the arrow until it stops.
Adding ingredients
• You can add ingredients into the mixing
bowl5 while the drive arm13 is lifted
up.
• During mixing, you can add ingredients
through the filling opening11 in the
splash guard12:
- Reduce the speed to 1 - 2.
- Add the ingredients.
Lowering the drive arm
DANGER of hand injuries by
crushing!
~ Never put your hand between the drive
arm13 and the housing. There is a risk
of injury from crushing when folding
down.
9. Press the unlock button1 and move the
drive arm13 all the way down. The un-
lock button1 pops out again.
The device is now fully assembled. On work-
ing with the device: see “Basic operation”
on page 29.
8. Basic operation
8.1 Power supply
DANGER! Risk of electric
shock!
~ Only connect the mains plug3 to a
properly installed and easily accessible
wall socket whose voltage corresponds
to the specifications on the rating plate.
The wall socket must still be easily ac-
cessible after the device is plugged in.
NOTE: when the device is used the first few
times, some odour may be generated by the
device due to the heating of the motor. This
is harmless. Please ensure adequate ventila-
tion.
1. Assemble the device for the desired
function.
2. Check that the speed control2 is set to
0 (off).
3. Plug the mains plug3 into a suitable
wall socket. The wall socket must still be
easily accessible after connection.
4. Pull out the mains plug3 before clean-
ing the device.
8.2 Safety functions
The device has several safety functions,
which are described below.
Functions only when the drive
arm is lowered
The device will only work if the drive
arm13 is correctly engaged in the lower
position and the unlock button1 has fully
popped out.
__379533_2110_B8.book Seite 29 Montag, 7. Februar 2022 4:03 16