Silvercrest SKM 600 C2 - Dismantling the Device; Pulse Function; Switching the Device On;Off and Selecting Speed

30
GB
Overheating protection
The device has an overheating protection
system. If the motor becomes too hot, the de-
vice automatically switches itself off:
1. Switch off the device.
2. Pull out the mains plug3.
3. Allow the device to cool down to room
temperature.
When the device has cooled down suffi-
ciently, it can be switched on again.
8.3 Switching the device on/
off and selecting speed
WARNING! Risk of material damage!
~ The mixing mechanism must not be op-
erated continuously for longer than
10 minutes at a time. You must then al-
low the device to cool down to room
temperature.
NOTE:
the device may move slightly while
you are processing large quantities of dough.
1. Switch the device on by turning the
speed control2 clockwise.
2. Start at a slightly lower speed, and slowly
increase to the desired speed (see “Over-
view of functions” on page 27).
3. Reduce the speed to speed 1 - 2 when
you are adding ingredients during oper-
ation through the filling opening11.
4. Set the speed control2 to 0 to switch
the device off.
NOTE: above all, the ideal speed depends
on the consistency of the material being
blended. The more liquid the contents, the
faster you can blend them.
8.4 Pulse function
• By turning the speed control2 to the po-
sition , you can briefly increase the
speed to the highest setting (8).
9. Dismantling the
device
DANGER from rotating parts!
~ Turn off the device and unplug the
mains plug3 from the wall socket be-
fore disassembling the device.
Lifting up the drive arm
1. Press the unlock button1 and fold up
the drive arm13 until it engages and
the unlock button1 pops out again.
Removing the mixing tool
2. Figure C: turn the mixing tool4/6/7
in the direction of the arrow until it can
be pulled downwards off the axle10.
Removing the splash guard
3. Turn the splash guard12 towards the
open lock symbol until it can be re-
moved.
Removing the mixing bowl
4. Turn the mixing bowl5 towards the
open lock symbol until it can be re-
moved.
Lowering the drive arm
5. Press the unlock button1 and move the
drive arm13 all the way down. The un-
lock button1 pops out again.
P
__379533_2110_B8.book Seite 30 Montag, 7. Februar 2022 4:03 16