Hot water dose setting
• Use the relevant procedure to enter the pro-
gramming function.
• Press the hot water selection key
.
• Hot water delivery will begin.
• Decide the required amount of hot water and
then press the key
again.
• Press the
key to quit the programming
mode.
Standard dose setting
• It is possible to enter pre-set values for the
group doses and hot water.
To do this, it is necessary to press the key
and hold it down for at least 10 sec-
onds until the flashing keys switch off.
The doses are:
1CN 2CN CONT. WATER
80 cc 120 cc 160 cc 45 sec.
NOTE
Setting a time of 0 seconds for the water causes
it to operate in continuous mode.
To Next Page
Loading...
