Additional functions
Also within the programming function (while no
pouring is in progress), pressing the “
” key
and then holding it down and pressing the “
”, opens the page for setting the parameters:
1
Software block activation to enter the
dose programming mode.
2 Keypad brightness adjustment.
3 Dose pre-infusion activation.
• The
key serves to enable the soft-
ware block to enter the dose program-
ming mode (key lit) or disenable it (key
off). To remove a software block for
programming, it is necessary to quit the
dose programming mode and follow
these steps: from OFF status, switch
the control unit to ON and as soon as
the Lamp-test begins, release the
key and press the
and keys
together, holding them down until the
Lamp-test is complete.
• The key, which flashes, is used to
choose the brightness of the keys from
the 9 pre-set levels. Pressing the
key will reduce the brightness setting as
far as minimum, to then start again from
the maximum value.
• Pressing the key will start the pre-
infusion (approx. 3 sec.) for dispensing
(key lit) or it will switch it off (key off).
Pressing the key will quit the parameter
setting functions and return to the dose program-
ming mode.
To Next Page
Loading...
