4020 OPERATORS MANUAL Page 43
Document No: 4020-M010 1st February, 1997 Issue 2.0
ITEM
CHECKED
Upon application of mains power, system powers-
up correctly
ALARM test function indicates alarms for all zone
inputs
FAULT test function indicates faults for all zone
inputs
Zone input delays function as programmed
Panel programming configuration sheets
completed
Ancillary control facilities function as programmed
Test supervised ACF outputs under open circuit
conditions
Test supervised ACF outputs under short circuit
conditions
Fault, Alarm, Bell and ACF3 and ACF4 Relays
operate okay
Bell and ACF isolate function operate when FIP
door open
Charger output voltage set correctly
Batteries fitted
Panel Quiescent current from battery (mains
isolated):
___Amps
Battery current with two zones in alarm:
___Amps
To Next Page
Loading...
