Autopilot settings
The autopilot settings can be split between settings done by the
user, and settings done during installation and commissioning of
the autopilot system.
• User settings can be changed for various operational conditions
or user preferences
• Installation settings are defined during commissioning of the
autopilot system. No changes should later be done to these
settings
Both user settings and installation settings depends on which
autopilot computer that is connected to the system.
NAC-2/NAC-3 Autopilot computer settings AC12N/AC42N Autopilot computer settings
The following sections describe the settings that can be changed by
the user. The settings are described per autopilot computer.
Installation settings are available in the documentation following
the autopilot computers.
Ú
Note: For Turn pattern settings, refer to "Turn pattern steering" on
page 19.
NAC-2/NAC-3 Autopilot computer
34
Software setup| AP44 Operator Manual
To Next Page
Loading...
