To Next Page

To Previous Page

Chapter 9-10 CP33 Setup menu

9.5 Loran C

Call up the menu bar, and...

7,5

load Loran C chain display

+/-

Leaf through the available chains - see listing further ahead in this

section.

If required, go to the slaves, and...

+/-

Toggle between available slaves (not all chains have more than one

slave)

0-9

...and it is possible to alter the figures in the time delay

If required, go to Offset, and key in a positive or negative offset

0-9

Key in a positive or negative offset to the time delay (toggle positive/

negative with +/-)

ENT

Confirm entry

To change the position readouts to Loran C mode, see section 4.1

under Position setup, where ‘Display position as’ can be toggled to

‘Loran C’.

Simrad CP33 User Manual

Questions and Answers: