Simrad CP33 User Manual

Index CP33 Chartplotter
Electrical connections - continued,
- power supply 10-8
ETA & AVN display 6-5,A-1
Factory settings 9-13
- master reset 9-14
- power off - reset 9-14
- return to all factory presets 9-13
Fundamentals 2-1
Global Positioning System 1-1
Glossary of terms A-1
GOTO function 3-14
- advance to next point 3-14
- restart to approaching point 3-14
- select NAV mode 3-14
- turn NAV off 3-14
GPS receiver type 9-2
How to get started 1-3
HDOP limit 4-10
Info windows 3-7
- cursor active but not placed on
any object or data 3-8
- cursor inactive 3-7
- cursor placed on route leg or
line section 3-10
- cursor placed on routepoint or
linepoint 3-11
- cursor placed on target 3-13
- cursor placed on trackpoint 3-12
- cursor placed on waypoint 3-9
- GOTO function 3-14
- PLOT function 3-15
Initial start-up 2-7
Installation,
- antenna DGPS MGL 3 10-6
- antenna GPS RS5640 10-6
- CP33 10-3
- DS33 10-5
- location for display unit 10-4
- notes 10-1
Interface setup, alarm output 9-8
Interface setup, NMEA 9-4,A-2
- default sentences 9-5
- description of sentences 9-6
- return to NMEA presets 9-13
Interface software version 9-2
Introduction 1-1
Key functions 2-3
-dedicated function keys 1-3
Key symbols in manual 1-2
Language 2-8,9-2
Light & contrast 2-7
Lines,
- delete all 9-13
- draw new line 3-15
- edit via chart 3-10,3-11
- edit via menu 5-10
- line list 5-9
- stored in the memory 5-9
Local time and date 4-1
Log 4-1,4-3
- reset 4-3
- speed calibration 9-1,A-1
- speed sensor 9-1
Loran C 9-10
- list of Loran C chains 9-11
Maintenance 10-10
Master reset 9-14
Measurement units A-2
- setup 9-1
Memory,
- delete 9-13
- used 9-13
Menu bar 2-4
Menu layout 2-5
Miscellaneous menu 8-1
MOB function back of front cover
- alarm and navigation 6-9
- check last activated MOB 6-9,8-3
- turn MOB function off 6-9
Naming of routes, points, etc. 2-7

Simrad CP33 Specifications

General

Brand	Simrad
Model	CP33
Category	GPS
Language	English