Software setup
First time startup
When the unit is started for the first time, or after a reset, the unit displays a series of dialogs.
Respond to the dialog prompts to make fundamental settings.
You can perform further setup and later change settings using the system settings dialogs.
Software setup sequence
1 General settings - refer to "System settings" on page 22.
• Make general settings as desired
• Configure the power control
2 Advanced settings - refer to "Advanced" on page 23.
• Enable or disable features
• Review the advanced setting options and make changes as desired
3 Source selection - refer to "Network settings" on page 32.
• Make sure that the proper external data sources have been selected
4 Feature setup
• Configure specific features as described later in this chapter
The settings dialog
The software setup is done from the settings dialog.
System settings
Boat settings
Used to specify the physical attributes of the boat.
Time
Configure time settings to suit vessel location, along with time and date formats.
Configure WheelKey
Configures the action of the WheelKey on the front of the unit.
4
22
Software setup | NSO evo3S Installation Manual
To Next Page
Loading...
