Receive waypoint
Select this option to allow a device capable of creating and exporting waypoints via NMEA
0183 to transfer directly to this unit.
Baud rate
This should be set to correspond with devices connected to the NMEA 0183 input and
output. The input and output (Tx, Rx) use the same baud rate setting.
Ú
Note: AIS transponders typically operate at NMEA 0183-HS (high speed), and will require
the baud rate to be set to 38,400.
Serial Output
Selection determines whether the data is output via Tx lines, and will enable editing of the
output sentences list.
Serial Output Sentences
This list allows control over which sentences need to be transmitted to other devices from
the NMEA 0183 port. Due to the limited bandwidth of NMEA 0183 it is desirable to only
enable the data that is required. The less sentences that are selected, the higher the output
rate of the enabled sentences.
Commonly used sentences are enabled by default.
40
Software Setup | NSS evo3 Installation Manual
To Next Page
Loading...
Need help?
General
