NMEA 0183 over Ethernet
NMEA 0183 data stream is also output over ethernet, which is made available to tablet
devices and PCs, via the internal wireless. The ethernet dialogue provides IP and port data
typically required for configuring the application on the third party device.
Ú
Note: Other MFDs cannot decode this information back to NMEA 0183, to use the data
as a source. To share data a physical NMEA 2000 or NMEA 0183 connection is still
required.
NMEA 2000 setup
Receive waypoint
Select this option to allow another device capable of creating and exporting waypoints via
NMEA 2000 to transfer directly to this unit.
Send waypoint
Select this option to allow this unit to send waypoints to another device via NMEA 2000.
Ethernet setup
No special setup is required for establishing an ethernet network, it is all plug-and-play. An
optional ethernet expansion device connected between the unit and another network
Software Setup | NSS evo3 Installation Manual
41
To Next Page
Loading...
Need help?
General
