17 Shutdown, decommissioning and
storage
17.1 Temporary shutdown
The system can be temporarily shut down by disconnecting it from electrical, pressurised air and hydraulic
outlets. If you wish to shut down the product temporarily, see also Section Storage. For further information,
please refer to relevant components’ operating and service manuals in Section General description. When
recommissioning the equipment, please refer to sections Commissioning and Technical specification in the
relevant components’ operating and service manuals.
17.2 Final decommissioning
Used equipment filled with lubricant must be decommissioned and disposed of in accordance with national
legislation and the procedures indicated in this operating and service manual.
Lubricants can contain chemicals that can contaminate the soil and the water system. Lubri-
cants must be disposed of appropriately. Observe any local laws and regulations concerning
disposal and recycling.
You can also return the product to Oy SKF Ab for disposal. Oy SKF Ab reserves the right to recover any costs
arising from the disposal.
17.3 Storage
The products must be stored as follows:
• Store in a dry, dust-free and well-ventilated space.
• Do not store the product for more than 24 months.
• Storage temperature range is +10...40 °C.
• Avoid direct sunlight and heat radiation.
• Store the products clear of the ground or floor.
• Protect the products against impacts, corrosion and dust.
To Next Page
Loading...
Need help?
General
