SKF UC - Page 37

Page 37
EN
Assembly instructions
Warning!
Centralized lubrication systems must
always be free of leaks. Leaking lubricant
is hazardous due to the risk of slipping
and injury. Be mindful of any lubricant
leaking out during assembly, operation,
maintenance, and repair of centralized
lubrication systems. Leaks must be
sealed without delay.
Lubricant leaking from centralized lubrication
systems is a serious hazard. Leaking lubricant
can create risks that may result in physical
harm to persons or damage to other material
assets.
Warning!
Lubrication lines must always be free of
leaks. Lubrication lines should always
be arranged so that air pockets cannot
form anywhere. Avoid changes in the
cross-section of the lubrication line
from small to large cross-sections in
the direction of flow of the lubricant.
When the cross-section does change,
the transition should be gentle.
The flow of lubricant in the lubrication lines
should not be hindered by the installation of
sharp bends, angle valves, or flap valves. Any
unavoidable changes in the cross-section of
the lubrication line should be realized as gentle
transitions. Sudden changes of direction
should be avoided if possible.
Warning!
Follow the safety instructions on the
lubricant's safety data sheet.
Lubricants are hazardous substances. The
safety instructions on the lubricant's safety
data sheet must be strictly followed. The safe-
ty data sheet for a lubricant can be requested
from the lubricant manufacturer.