Page 7
EN
Assembly instructions
The operator of the described product
must ensure that the assembly instruc-
tions are read and understood by all
persons responsible for assembly, op-
eration, maintenance, and repair of the
product. The assembly instructions
must be kept readily available.
Note that the assembly instructions
form part of the product and must ac-
company the product if sold to a new
owner.
1. Safety instructions
In addition to the assembly instructions,
statutory regulations and other general
regulations for accident prevention and
environmental protection must be ob-
served and applied.
1.2 Authorized personnel
Only qualified technical personnel may install,
operate, maintain, and repair the products de-
scribed in the assembly instructions. Qualified
technical personnel are persons who have
been trained, assigned and instructed by the
operator of the final product into which the
described product is incorporated. Such persons
are familiar with the relevant standards, rules,
accident prevention regulations, and assembly
conditions as a result of their training, experi-
ence, and instruction. They are authorized to
identify and perform necessary actions while
avoiding any risks which may arise.
The definition of qualified personnel and the
prohibition against employing non-qualified
personnel are laid down in DIN VDE 0105 and
IEC 364.
The described product is manufactured in accor-
dance with the generally accepted rules and
standards of industry practice and with occupa-
tional safety and accident prevention regulations.
Risks may, however, arise from its usage and
may result in physical harm to persons or dam-
age to other material assets. Therefore the
product may only be used in proper technical
condition and in observance of the assembly
instructions. In particular, any malfunctions
which may affect safety must be remedied
immediately.
1.1 Intended use
The UC and UD gear pump units are vertically
or horizontally arranged units that are used in
hydraulic or circulating-oil lubrication systems.
All off-the-shelf lubricants and hydraulic oils
in the viscosity range of between 20 and
1000 mm
2
/s are conveyed.
The use of synthetic oils requires prior approval
from SKF Lubrication Systems Germany GmbH.
Any other usage is deemed non-compliant
with the intended use.
To Next Page
Loading...
Need help?
General
