SKF UC - Maintenance

Page 46
EN
8. Maintenance
8. Maintenance
Warning!
Work on products that have not been
de-energized may result in bodily in-
jury. Assembly, maintenance and repair
work may only be performed on prod-
ucts that have been de-energized by
qualified technical personnel. The supply
voltage must be switched off before
opening any of the product's
components.
Products from SKF Lubrication Systems are
low-maintenance. However, all connections
and fittings must be regularly inspected for
proper seating to ensure proper function and
to prevent hazards from arising.
If necessary, the product can be cleaned using
mild cleaning agents that are compatible with
the product's materials (non-alkaline, non-soap).
For safety reasons, the product should be
disconnected from the power supply and the
hydraulic and/or compressed air supply.
It must be ensured that no cleaning agent
enters the interior of the product during
cleaning.
It is not necessary to clean the interior of the
product if the product is operated normally
and intercompatible lubricants are used.
The interior of the product must be cleaned if
incorrect or contaminated lubricant is acciden-
tally filled into the product. If this occurs,
please contact the Service department of SKF
Lubrication Systems for assistance.
Dismantling of the product or individual
parts thereof within the statutory war-
ranty period is not permitted and voids
any claims.
Only original spare parts from SKF
Lubrication Systems may be used.
Arbitrary alterations to products and
the use of non-original spare parts and
accessories are not permitted and nullify
the statutory warranty.
SKF Lubrication Systems shall not be held li-
able for damages resulting from improperly
performed assembly, maintenance and repair
work on the product.