Skycut C24 - User Manual

1
Skycut Series C with SignCut Pro2
January 3, 2020
Do NOT read this entire manual… unless you want to.
• At the start of Chapters 1 - 4 are short sections with references to find what you need plus some important
reminders. PLEASE read these short sections at the very least and refer back to them, when needed.
• Chapters 1 and 2 are very important in terms of correctly setting up your Skycut to work with SignCut Pro
and learning the ins and outs of cutting.
• Chapter 3 covers contour cutting (aka print and cut) applications.
• Chapter 4 covers the Skycut accessory tools.
• Chapter 5 covers several SignCut Draw functions of interest: vectorizing, editing, and engraving fills
It’s not practical to print this entire manual because:
• It’s a waste of paper and ink if you only ever need certain sections.
• The live links to videos and web sites in the manual will not work.
• This manual will be updated from time to time.
• You cannot search on individual words.
Also:
• Note the green icons which link to videos related to the section in which they are located. These
videos will enhance your learning experience.
________________________________________________________________
© 2019-2020 Sandy McCauley All Rights Reserved

Summary

Introduction and Setting Up

Support

Information and resources for user support and technical assistance.

Safety and Warnings

Essential safety guidelines and warnings for operating the Skycut cutter.

Control Panel

Introduction to SignCut Pro 2

Overview of SignCut Pro 2 software, installation, and basic screen layout.

Connecting the Skycut to Your Computer

Instructions for connecting the Skycut cutter to a computer via USB or Wi-Fi.

Cutting

What You Need to Understand About Cutting

Set the Blade Height Above the Material

Method for correctly setting the blade height relative to the material for optimal cuts.

Cut Settings

Comprehensive guide to various cut settings and parameters for the Skycut.

Blade Offset

Explanation of blade offset and recommended settings for different blade types.

Setting the Origin before Cutting

Procedures for defining the starting point (origin) for cutting operations.

Setting an Origin Using the Camera

Using the built-in camera for precise origin setting and calibration.

Scale Calibration

Procedure for calibrating the Skycut's scale for accurate dimensions.

Test Cutting Flow Chart for the Skycut

A flowchart to guide users through troubleshooting test cuts and identifying issues.

Suggested Cut Settings for Various Materials on Skycut

Contour Cutting

What Is a Contour Cut

What is a Camera Calibration?

Importance and purpose of camera calibration for accurate contour cutting.

Camera Calibration Procedure

Step-by-step guide to calibrating the Skycut's camera for precise alignment.

Performing a PNC in SignCut Pro

Overall process for performing a print and cut job within SignCut Pro.

Preparing the Registration Marks

Contour Cutting Project - Accuracy Test

Inaccurate Cuts

Adjusting the Calibration Values

How to fine-tune camera calibration values without recalibrating from scratch.

Contour Cutting Multiple Images and Adding Intermediate Registration Marks

PNC from USB Flash Drive

Appendix A Troubleshooting FAQ’s

Communication Issues

Troubleshooting common communication problems between the Skycut and computer.

Operating Issues

Cutting;Drawing Issues

Addressing problems related to inaccurate cutting, drawing, and material feeding.

Skycut C24 Specifications

General

Brand	Skycut
Model	C24
Category	Plotter
Language	English