Skycut C24 - Suggested Settings for Various Accessories 1

121
4.05 Suggested Settings for Various Accessories
1
Application/Material Tool Used Passes Force Speed
Tool
Height
Surface Other Comments
Drawing on Cardstock Test pen 1 30 11 20 mat
Embossing Cardstock - 65
lb (177 gsm) Recollections
Embosser -
large end
4 80 6 10
Shelf Liner
taped to mat
Used 2 shadow layers of 0.01" (0.25mm)
to increase thickness; also tested Fun Foam
taped to mat with same results
Engraving Acrylic
Scratch
Engraver
1 110 8 20 mat Used a Line Fill of 0.004" (0.1 mm)
Engraving Aluminum (36
gauge)
Scratch
Engraver
1 20 11 15 mat Used a Line Fill of 0.004" (0.1 mm)
Engraving Copper (36
gauge)
Scratch
Engraver
1 30 11 15 mat Used a Line Fill of 0.004" (0.1 mm)
Engraving Metal Tag (Al)
Scratch
Engraver
1 44 9 15 mat Used a Line Fill of 0.004" (0.1 mm)
Engraving Vellum
Scratch
Engraver
1 38 11 15 mat Vellum was medium weight
Scoring Cardstock -
Georgia Pacific 110# index
Embosser -
small end
2 155 8 20 mat
Make sure Blade Offset and Overcut are set to 0; test with a small shape first; mirror shapes for
embossing.
Tool Height = number of Post-It notes used to set blade tip distance above the material: Refer to Section
2.01.3.