Skyjack SJ85AJ User Manual

SJ85AJ 208932AEA
67
Loading/Unloading Section 6 – Additional Procedures
6.3-2 Locking the Turret
1. Ensure that turret is positioned so that turret
transportation lock tube (item
2
– Figure 26) is
aligned into one of two turret locking points on
the chassis.
2. Lift turret lock retaining pin (item
1
– Figure
26) and rotate 90 degrees. Lower turret lock
retaining pin into locked position.
Figure 26 Turret Transportation Lock
6.3-3 Lifting
1. Rotate the boom and position the MEWP as
shown in Figure 29.
2. Turn main power disconnect switch to off
position.
3. Clear platform of all personnel, tools and
materials.
WARNING
When lifting the MEWP, lifting devices must be
attached to designated lifting points only (refer to
Figure 28).
WARNING
Use chains with load capacity sufcient to
withstand MEWP weight. Refer to the serial plate
of the MEWP for specic weight.
4. Properly adjust rigging to ensure MEWP remains
level during lifting. See Center of gravity location
(Figure 29).
1
2
Figure 27 Turret Transportation Locking Points
5”
(12.7 cm)
C
L
Turret
Transportation
Locking Point
Turret
Transportation
Locking Point
Figure 28 Lifting Points
Figure 29 Center of Gravity

Skyjack SJ85AJ Specifications

General

Brand	Skyjack
Model	SJ85AJ
Category	Lifting Systems
Language	English